Things That Can Be Used as a Stylus

Using Aluminum foil has already been mentioned past Mooseman. Since in that location are unlike ways of crafting your ain stylus, I'd similar to expand on this a scrap.

The following method found on CNET uses aluminum foil as well simply likewise includes a Q-tip to accomplish a screen gentle meeting place:

Hither'due south what you'll need:

• A cotton swab (aka "Q-tip")
• Aluminum foil
• Scissors
• Tape
• A pen

Steps:

1. Remove the ink from the pen.
2. Cutting the cotton wool swab at a abrupt angle and insert it into the oral fissure of the pen. Secure with tape.
3. Wrap the foil around the neck of the pen, a couple of centimeters higher up the tip of the cotton fiber swab. Wrap tightly, and secure with tape at the pinnacle.
4. Moisten the cotton swab with a driblet of water. (No, this will not harm your tablet'south or phone's screen.)

This is what the procedure should look like:

---

Another method found on lifehacker uses conductive foam instead of aluminum foil. Here'south a video in case you don't like reading instructions.

What you lot'll need:

• A small piece of conductive cream ^{(the kind that microchips and other pocket-size electronic parts come embedded in)}
• Scissors
• A not insulated wire ^{or a wire stripper to remove insulation} more than twice the length of your pen
• Tape
• A pen

Steps:

1. Remove the ink from the pen.
2. Disassemble the rear of the pen then that you get a tube. If you can't easily accomplish this, yous may want to use a dissimilar pen or endeavour to interruption the rear off.
3. Cut a small stripe off of the conductive foam then it's a little bit wider than the tip of the pen.
4. Wrap the wire around the cream multiple times at about 1-tertiary of the stripe.
5. Stuff the piece of conductive foam into the tip of the pen, making sure that some of the foam sticks out of the pen and the wire sticks out of the rear of the pen.
6. Wrap the excess wire around the pen in a spiral class (in management of the tip).
7. Fix it in position with tape so that you're touching the wire with your skin while holding the pen normally.
8. Trim the sticking out foam so that it has a more round shape.

This is how it might look like:

armstrongraceiziendas1939.blogspot.com

Source: https://lifehacks.stackexchange.com/questions/6081/substitute-for-a-tablet-stylus

Share this post